Table of Contents
1. Introduction
Goki SmartLocker is an easy-to-use device that can provide your guests with the same access methods for your lockers that are used for the rest of the property.
The Goki SmartLocker supports the latest technologies including:
4-digit DoorCode access
SmartKey Access via web app and native Goki app
Wireless connectivity via GokiAir
2. Technical Specifications
Door Thickness | Standard 25mm, other sizes by self-supply of longer screws |
Working Temperature | -20~70 degrees Celsius extreme low or high temperatures can reduce the working capacity of the batteries) |
User Interface | White light display |
PIN Pad Display | Capacitive touch button |
Warnings | Multiple incorrect PIN combination warning function |
Working Current | less than 200 mA |
Power Supply | 4pcs AA batteries |
Battery Location | Inside of locker |
Emergency Power Supply | Power externally via USB-micro |
Weather Resistant | Not designed to be used outdoors |
Technology between Goki SmartLocker and mobile phone | Bluetooth directly or via Bluetooth and WiFi if a GokiAir gateway device is connected |
Opening Methods | 1. SmartKey 2. DoorCode 3. Remote Unlock 4. Wristband/ Keycard backup |
3. SmartLocker Dimensions
Latch
4. Smartlocker Installation Guide
4.1 Door opening:
Select a position on the locker door with a suitable height and 58mm distance to the opening edge of the door.
Drill a centre hole of diameter≥20MM.
Drill 2 small holes, 40mm above and below the center hole as shown in Picture 1
4.2 Installing the lock body and lock panel (See Picture 2)
Pull the PCB cable through the centre hole
Straighten the panel by making sure the screws can fit through the top and bottom screw holes
Connect the PCB cable with the lock body
Take off the Battery cover and secure the lock body using the 2 4*25screws
Put in 4 AA 1.5V alkaline batteries and fix the cover using the 3*6 countersunk screw.
Picture 2
4.3 Installing the lock catch
Use the 3 4*16 countersunk self-tapping screws to fix the lock catch to the inside of the locker, as shown in pictures 3-1 and 3-2.
Picture 3-1
Picture 3-2
After successfully installing your SmartLocker, the next step is to connect it to the bed using the Spaces App by following the instructions I've included here.
Note
The USB-C emergency jump under the locker screen should not be used to recharge the battery. By using a power bank with a compatible USB-C cable, you can jumpstart the SmartLocker and gain access to the locker; you should replace the batteries inside the locker. You will need 4pcs AA batteries.