Table of Contents
1. Introduction
The Goki SmartAccess Panel works with a wide variety of electronic locks/gates e.g. lifts, sliding doors, magnetic strikes and a lot more.
The SmartAccess can be installed by your in-house maintenance team but for more complicated installs, we suggest involving an electrician or a company that services the equipment.
2. Technical Specifications
The wiring harness can look a bit daunting; for basic installs, four wires are required.
1. 12V (RED).
2. GND (BLACK).
3. COM (YELLOW).
4. NO - To the lock mechanism (GREEN).
Smart Access Controller K2
Model: K2
Dimensions: W79mm x H125mm x T15.5mm
Material: Aluminium frame/Tempered glass panel
Communication: Bluetooth 4.1
Supporting systems: Android 4.3/IOS 7.0 above
Standby current: ≈15mA
Operating current: ≈1A
Power supply: DC 12V
Unlocking time: ≈1.5S
Waterproof level: IP66
Card capacity: 20,000
Smart Access Controller K3
Model: K3/K3F
Dimensions: W80mm x H126mm x T19mm
Material: ABS/Acrylic panel
Supporting systems: Android 4.3/IOS 7.0 above
Standby current: ≈28mA(Activate back lighting)
Operating current: ≈1A
Power supply: DC 12V
Waterproof level: IP67
Card capacity: 2000
Number of Passwords: 500
Fingerprint capacity: 100(K3F only)
Accessories
Access controller x 1
Manual x 1
Mounting plate x 1
Screw: 4x1
Hex screwdriver x 1
3. Smart Access Installation Guide
3.1 Drill a hole for the cable
Drill a hole at the appropriate position to make space for the cable to connect to the power source.
3.2 Install the mounting plate
Remove the mounting plate from the access controller and fix it on the wall with four screws.
3.3. Wiring
Cut off the controller of the cable, strip and connect the leads to the appropriate ports of the power supply according to the illustration.
3.4 Install the access controller
Fit the access controller into the hook and fix it on the mounting plate with a screw in the bottom.
3.5 Pair the access controller with the Spaces App
After successfully installing your SmartAccess, the next step is to connect it with the Spaces App by following the instructions provided here.
4. Reset the Smart Access panel
Smart Access K2
In order to reset the SmartAccess Panel you need to Open 4x Philips head screws & 1x hex screws to get into the panel, then click the button on-screen and hold it down till it beeps.
Smart Access K3
Connect the blue wire (SW) to the purple wire (IN).
Connect SW and IN to black wire (GND) for 3 seconds.
Disconnect black wire (GND) on a beep.
Repeat step 2 and step 3 twice till 2 short beeps are heard.